Watch Press Set Back Case Closer Watch Repair Tool Kit Cast Iron Professional with 12 Addition Dies

Operation Instruction:
1. choose one die bigger than the watch surface and install it on the top of the machine.
2: choose another die smaller than the rear cover, install on the bottom of press machine.
3: put the watch on the bottom die, make sure it is on the right position.
4. gently push the handle bar.
5: you should put table cloth mat, so that can protect your watch.

Product dimension: 7″ x 3″ x 6″ (press)
Material: iron+ plastic

Package Included:
1 x watch press machine
12 x dies

Product Features

  • ▶The watch press is made of cast iron, sturdy and durable. The 12 dies is made of ABS plastic.
  • ▶Ideal watch press for closing snap back type watch-cases, installing crystals and bezel rings.
  • ▶It comes with an assortment of 12 dies to allow for 50/48 46/44 42/40 38/36 34/33 32/31 30/28 26/24 23/21 20/18.
  • ▶This dies snap on and off quickly and easily so you will gain some time while you use the press
  • ▶High quality compression spring, longer service life,Ideal watch press for closing snap back type watch-cases

Leave a Reply

Your email address will not be published. Required fields are marked *